None WUI-01 Bedienerhandbuch PDF herunterladen (Seite 7)

8.

9.

Check Out Instructions

1.

Take the wire nuts provided and screw down

tight over the joined stripped wires, ensuring

that no wires are showing.

Check installation is secure and safe, routing

leads away from the burner.

Turn on the gas and electrical supply to the

appliance.

Turn the room thermostat to call for heat.

Test appliance for proper ignition and operation.

Verify that the Power-On LED is on during

the warm-up.

During warm-up, use a voltmeter and measure

the voltage across the ignitor leads. The voltage

should be between 100 VAC and 120 VAC.

Make sure the Nitride ignitor does not remain

on for no more than a few seconds after the

gas ignites.

Replace burner compartment door and secure

wiring.

Turn room thermostat to normal setting.

2.

3.

4.

5.

6.

7.

Place the universal upgrade label on the front

of the appliance with the date of installation

and your contact information.

8.

9.

5

1 2 3 4 5 6 7 8 9 10 11 12 ... 19 20

Kommentare zu diesen Handbüchern

Keine Kommentare